GB 11566-2024 Translated English of Chinese Standard (GB 11566-2024, GB11566-2024): External projections for passenger carshttps://www.chinesestandard.net, 2024. 11. 2. - 19ÆäÀÌÁö This document specifies the general requirements, special requirements and test methods for the external projections for Category-M1 vehicles. This document is applicable to Category-M1 vehicles. This document does not apply to external indirect vision devices and traction devices. |
¸ñÂ÷
3 | |
Scope | 4 |
General Requirements | 6 |
Special Requirements | 7 |
Test Methods | 15 |
Judgment of the Same Type | 18 |
ÀÚÁÖ ³ª¿À´Â ´Ü¾î ¹× ±¸¹®
aerial is mounted auxiliary supporting bumper cover Component Mounted components that protrude contact point covers and wheel decorative definitions are added determining the floor Diagram of Measurement diameter of 100 dimensions document exceed 40 mm exhaust pipe external surface extreme outer edge Figure flat-end indenter floor line force of 500 gap width GB/T greater than 25 Headlight Visor height h height is less hub covers laden vehicle less than 2.5 less than 40 license plate Light Ring luggage compartment lid luggage rack manufacturer measured section Measurement Method mirrors and surveillance NOTE point Q protrude the external protruding components protruding height Protruding Reinforcing Rib rack and ski rack or ski radius of curvature requirements of 4.5 requirements of Chapter Retractable Schematic Diagram ski rack sphere supporting surface surveillance camera-monitor-recording device surveillance mirror transceiver usage position Vehicle Body Panel vertical projection visor and light wheel nuts wheel trim covers windshield wipers